|Machine Name:||Commercial Potato Chips Cutter||Voltage:||380V / Customized|
|Power:||1.1 KW||Capacity:||500 Kg/h|
|Material:||Stainless Steel||Keywords:||Food Chopper Vegetable Cutter|
fruit vegetable washer machine,
vegetable cutter slicer machine
Product description of China electric spiral green mango commercial potato chips fry potato cutter :
Slicing: If only a slicer is installed and a wire cutter is not installed, the finished food is sliced. By adjusting the thickness adjustment handle, you can get ingredients of any thickness between 2-20mm.
Shredding: You need to install a slice and a cutting knife at the same time. You do n’t need to install a dicing knife. The finished ingredients are silk. The thickness of the ingredients is adjusted by the thickness adjustment handle. The width of the ingredients is determined by the width of the cutter.
Diced; the finished ingredients are diced with a knife, a wire knife and a dicing knife, and formed at one time.
1. Large-capacity inlet
2. User-friendly design for easy cleaning and discharge
3. Stainless steel body is resistant to corrosion and not easy to rust
4. Waterproof switch carefully selected waterproof cover safe and reliable
5. The machine feet are designed for rollers.
All maintenance work must be performed with the power off.
1 After each use, carefully clean up the machine. When cleaning, do not use sharps to contact the conveyor belt and pressure vegetable belt, or spray with a water pipe.
2. If the conveyer belt and the pressure vegetable belt are found to be slippery, adjust the tightening bolts or the spring pressure to a proper position in time. The tension or pressure at both ends of the belt should be basically equal, otherwise the deviation of the conveyor belt or pressure vegetable belt will occur.
3 Check the gold and wear of the triangle belt, and adjust and replace it in time. When the V-belt is loose, loosening the tensioning mechanism bolts for adjustment is to tighten the bolt after the V-belt is tightened.
4 Fill oil into ratchet, gear and sprocket once per shift. Use No. 20 engine oil. It is advisable to add ten drops at a time. The grease in the bearing should be added and replaced according to the use situation. Use calcium-based grease for lubrication. fat.
5 During machine work, if the machine sounds abnormal, you must stop and check immediately, and then continue working after troubleshooting.
Contact Person: Ms. Amanda Lee
Tel: +86 18037576821